This artical will teach you how to work on StaySign's hot stamping machine.
1.Pull up the rocker, make the heating board fully open and plug in the power, turn on the main power switch, and the indicator light is on;
2, adjust the left side of the temperature regulator (three buttons that represent the bits, 10, one hundred), press the + or - to proper temperature (150 ℃ -- 150 ℃), the heating time is about 15 to 20 minutes;
3. Adjust the right timer knob and adjust it to the appropriate time (the time is long myopic and different materials);
4. When the temperature reaches the set value, the machine will automatically enter the thermostatic state;
5, will lie flat, then stacked into the picture (photo page size must be greater than the plate size, in order to prevent the edges have indentation, affect product final effect), the rocker arm bearing force; Note: the pressure must not be too large, otherwise it will cause the rocker deformation!
6. When the buzzer rings, remove the plate (after removing it, it must be dipped in cold water to prevent the ink from spreading).
7, baking sheet metal temperature is in commonly 170-170 ℃, time in 20-40 seconds, baked porcelain plate temperature is in commonly 180-190 ℃, in 60-90 seconds
Adjust thePressure: adjust the pressure adjusting nut above the heating plate to increase or decrease the pressure;
Time: adjust the timer regulator to the appropriate time;
Temperature: adjust the left side of the temperature regulator (three buttons that represent the bits, 10, one hundred), press the + or - to proper temperature (150 ℃ -- 150 ℃).
Note: when you work in large batches, you should stop the device for about 60 minutes (two minutes).